Tech Inspection Information
A vehicle Tech Inspection is mandatory for all drivers wishing to participate in an ORPCA Autocross event. Every Autocross event offers a Tech Inspection. If you do not have a 2021 Tech Inspection sticker, please arrive at your first event by 7:30am to get registered and get the Tech Inspection done.
Make sure your helmet is a M/SA2015 or newer helmet. Loaner helmets are not available due to Covid-19 restrictions.
If you have questions regarding your vehicle and its condition prior to an event please contact the ORPCA Autocross Chairman at: email@example.com.
Failure to pass any of the 22 listed inspection points below will result in your vehicle being barred from grid and entering our competition until corrected
ORPCA/PCA requires a Snell SA or M 2015 or newer. A face shield is required for cars without windshields. Loaner helmets are not available due to Covid-19 restrictions.
- DRIVER’S LICENSE:
Valid driver’s license required.
Must be present and adequate. Where installation is other than factory design, the seat belts (and harness if used) must be installed according to manufacturer’s directions using proper hardware, be in good condition, secure, and tight.
- ROLL BARS/CAGES:
Roll bars are required in open vehicles driving in Modified classes, cages are optional. Roll bars/cages must be equipped with adequate padding. Roll bars/cages, when required must meet PCR Guidelines.
- BRAKE PEDAL:
Free return and in good operating condition. Firm brake pedal.
No major cracks. Bolt-on windshields may be removed.
- GAS CAP:
Gasket intact and gas cap tightened
No rust or damage to suspension or chassis parts that affect the integrity of the chassis or brakes.
- STEERING and SUSPENSION:
No excessive looseness in steering or suspension. Axle and shock bolt tight. Ball joints in good condition. Tie rods secure. Check axle boots and oil seals in good condition. Check half-shaft bolts and shock bolts.
- WHEEL BEARINGS:
Correct adjustment, check for play, and no damage.
For Porsche 356 models, no positive camber on the rear of the car.
No cracks. No bends. All lug nuts must be torqued to manufacturer’s specifications, minimum on diameter of engagement. Snap-on wheel covers and trim must be removed from steel wheels.
Must be free of visible cracks or belt showing. Clearance between tires and any potential rubbing point must be in compliance of chosen car classes in PCRs.
- BRAKE FLUID:
Level in reservoir between minimum and maximum line.
Securely fastened and in good condition. No acid leaks or corrosion. Check fuel lines under battery trays on 914’s. The positive (+) terminal on all batteries should be covered by cap or tape.
Must be in safe condition, no leaks, securely mounted.
- FLUID LEAKS:
No fluid leaks of any kind (oil, gas, brake, coolant, or transmission fluid).
- THROTTLE RETURN:
Freely operating and good springs on cars so equipped.
- DOORS, HOODS AND DECK LIDS:
Must fasten securely.
- CAR INTERIOR:
Loose items removed from trunk and interior.
A maximum noise level of 96db is allowed. Vehicles which exceed that limit will be removed from grid until corrected.
- CAR NUMBERS:
Car numbers must be affixed on both sides of car. See more info on numbers here: ORPCA AX Rules & Regulations.